• No Direction-Control Signal Needed

• Maximum Data Rates

• 110 Mbps (Push Pull)

• 1.2 Mbps (Open Drain)

• 1.2 V to 3.6 V onA Port and 1.65 V to 5.5 V on B Port (VCCA≤VCCB)

• No Power-Supply Sequencing Required – Either VCCA orVCCB Can Be Ramped First

• Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II

• ESD Protection Exceeds JESD 22 (A Port)

• 2000 V Human Body Model (A114-B)

• 150 V Machine Model (A115-A)

• 1000 V Charged-Device Model (C101)

• IEC 61000-4-2 ESD (B Port)

• ±8 kV Contact Discharge

• ±6 kV Air-Gap Discharge

All trademarks are the property of their respective owners.

This 8-bit non-inverting translator uses two separate configurable power-supply rails.The A port tracks the VCCA pin supply voltage. TheVCCA pin accepts any supply voltage between 1.2V and 3.6 V. The B port tracks theVCCB pin supply voltage. The VCCB pin accepts anysupply voltage between 1.65 V and 5.5 V. Two input supply pins allows for low Voltage bidirectionaltranslation between any of the 1.2 V, 1.8 V, 2.5 V, 3.3 V, and 5 V voltage nodes.

When the output-enable (OE) input is low, all outputs are placed in the high-impedance(Hi-Z) state.

To ensure the Hi-Z state during power-up or power-down periods, tie OE to GND through apull-down resistor. The minimum value of the resistor is determined by the current-sourcingcapability of the driver.