USB v2.0 On-the-Go compliant

Dual role capable, can act as either Host or Device

Low speed(1.5Mb/s) and full speed(12 Mb/s) operation in host mode

Full speed USB operation in Device mode

Supports 32 endpoints

On-chip USB transceiver

Up to 16 MIPS performance

16 x 16 Hardware Multiply, Single Cycle Execution

12-bit x 16-bit Hardware Divider

C Compiler Optimized Instruction Set

Run, Idle and Sleep modes

Multiple, Switchable Clock Modes for Optimum Performance and Power Management

Run mode: 1 mA/MIPS, 2.0V Typical

Sleep mode Current Down to 100 nA Typical

Standby Current with 32 kHz Oscillator:2.5 uA,2.0V typical

Self-Reprogrammable under Software Control

10,000 erase/write cycles

20 year data retention

EEprom emulation capable

Internal oscillator support - 31 kHz to 8 MHz, up to 32 MHz with 4X PLL

On-chip LDO Voltage Regulator

JTAG Boundary Scan and Flash Memory Program Support

Fail-Safe Clock Monitor – allows safe shutdown if clock fails

Watchdog Timer with separate RC oscillator

10-bit ADC, 16 channels, 500k samples per second

Three Analog comparators

CTMU supports Capacitive Touch applications

Peripheral Pin Select allows I/O remapping of many peripherals in real time

4xUART Modules with LIN and IrDA support, 4 Deep FIFO

3xSPI ™ Modules with 8 Deep FIFO

3xI2C™ Modules with Master and Slave Modes

Five 16-bit Timer Modules

Up to 9 Input Capture and 9 Output Compare/PWM with dedicated time base

Hardware RTCC, Real-Time Clock Calendar with Alarms

PMP, Parallel Master Port, with 16 Address Lines, and 8/16-bit Data