The MAX2235EUP+ low-voltage, silicon RF power amplifier (PA) is designed for use in the 900MHz frequency band. It operates directly from a single +2.7V to +5.5V supply, making it suitable for use with 3-cell NiCd or 1-cell Li-Ion batteries. The device delivers +30dBm (1W) typical output power from a +3.6V supply or +28dBm from a +2.7V supply. The MAX2235's gain is adjustable over a 37dB range. A power-control pin controls gain and bias to maintain optimum efficiency, even at lower output power levels, thus extending the operating life of the battery. At +30dBm output power, efficiency is typically 47%. An additional power-saving feature is a shutdown mode that typically reduces supply current below 1μA. A key feature of this PA is its autoramping capability. During turn-on and turn-off periods, the RF envelope is controlled to approximate a raised cosine on the rising and falling edge, thereby minimizing transient noise and spectral splatter. The ramp time is set by selecting the value of an external capacitor. The MAX2235EUP+ is intended for use in constant envelope applications such as AMPS, two-way paging, or FSK-based communications in the 900MHz ISM band. The device is available in a thermally enhanced 20-pin TSSOP package with a heat slug.
Feature
800MHz to 1000MHz Operation
High Output Power at 836MHz
+32.5dBm at +5.0V
+30dBm at +3.6V
+29dBm at +3.0V
+28dBm at +2.7V
+2.7V to +5.5V Single-Supply Operation
Automatic Power-Up/Power-Down Ramp
Direct On/Off Keying (OOK) without Intersymbol Interference or VCO Pulling
37dB Power-Control Range
47% Efficiency
< 1μA Supply Current in Shutdown Mode
Small 20-Pin TSSOP Package with Heat Slug
Applications